| SF284 |
While removing bolting beets manually, it must be ensured that long-sleeved working clothes, sturdy footwear and protective gloves are worn. |
– |
– |
| SF275-VEAC |
For the period after application until shortly before harvest in field crops, it must be ensured that long-sleeved working clothes and sturdy footwear are worn during successive work/inspections with direct contact with the treated crops/areas. |
– |
– |
| NW800 |
Application not allowed on drained areas between 1 November and 15 March. |
– |
– |
| NW607-2 |
When applying the product on areas adjacent to surface waters - except only occasionally but including periodically water bearing surface waters - the product must be applied with equipment which is registered in the index of 'Loss Reducing Equipment' of 10 September 2013 (Federal Gazette AT 23.10.2013 B4) as amended. Depending on the drift reduction classes for the equipment stated below, the following buffer zones must be kept from surface waters. In addition to the minimum buffer zone from surface waters stipulated by state law, the ban on application in or in the immediate vicinity of waters must be observed at all times for drift reduction classes marked with "*". Violations may be punished by fines of up to 50 000 EUR. |
– |
– |
| NT140 |
Application of the product with a water application rate of less than 150 l/ha has to be conduct-ed with a field sprayer that is listed with a drift reduction class of at least 50 % in the list of "loss-reducing devices" in the first announcement on the entry of tested device types in the descrip-tive list pursuant to Section 52 (2) of the Plant Protection Act of September 10, 2013 (BAnz AT 23.10.2013 B4), as amended. The conditions of use for application with a drift reduction of at least 50 % must be complied over the entire area to be treated. |
– |
– |
| NT108-1 |
A buffer zone of at least 5 m must be kept from adjacent areas (except agriculturally or horticulturally used areas, roads, paths and public places). In addition, in an adjoining strip of at least 20 m, the product must be applied using loss reducing equipment which is registered in the index of 'Loss Reducing Equipment' of 10 September 2013 (Federal Gazette AT 23.10.2013 B4) as amended, and be registered in at least drift reducing class 75 %. Neither loss reducing equipment nor a buffer zone of at least 5 m are required if the product is applied with portable plant protection equipment or if adjacent areas (field boundaries, hedges, groups of woody plants) are less than 3 m wide. A buffer zone of at least 5 m is also unnecessary if the product is applied in an area which has been declared by the Biologische Bundesanstalt in the "Index of regional proportions of ecotones" of 7 February 2002 (Federal Gazette no. 70 a of 13 April 2002), as amended, as agrarian landscape with a sufficient proportion of natural and semi-natural structures, or if evidence can be shown that adjacent areas (e.g. field boundaries, hedges, groups of woody plants) were planted on agriculturally or horticulturally used areas.
|
– |
– |
