Data as of: 2026-09-02 Administration DE EN
Plant Protection Product Search

« Indications · to the product

CLAYTON RELIC

Use number: 00B253-00/00-001

Crops
apple, pear, quince, crab apple
Pests
tortrix moth (Tortricidae)
Area of use
Outdoors
Field of activity
Insecticide
Application technique
spraying
Applications per crop
Applications per growing season
1
authorised until
2027-10-31

Application rates

ConditionProduct rateWater rate
150 CH 300 – 1,500 LH

Pre-harvest intervals

CropPre-harvest intervalRemarksexcluded
apple 7 days
pear 7 days
quince 7 days
crab apple 7 days

Timing of application

Restrictions

Code Text Crop Buffer zone
NT1095-2 To protect the environment, the product must be applied with equipment which is registered in the index of 'Loss Reducing Equipment' of 10 September 2013 (Federal Gazette AT 23.10.2013 B4) as amended. Depending on the equipment used and the drift reduction classes stated below, the respective provisions for use specified in the index as well as the buffer zones from adjacent areas stated below must be kept. It is not necessary to keep the provisions of use and the buffer zone where adjacent to the treated area a professionally used agricultural or horticultural crop is grown.
NW607-2 When applying the product on areas adjacent to surface waters - except only occasionally but including periodically water bearing surface waters - the product must be applied with equipment which is registered in the index of 'Loss Reducing Equipment' of 10 September 2013 (Federal Gazette AT 23.10.2013 B4) as amended. Depending on the drift reduction classes for the equipment stated below, the following buffer zones must be kept from surface waters. In addition to the minimum buffer zone from surface waters stipulated by state law, the ban on application in or in the immediate vicinity of waters must be observed at all times for drift reduction classes marked with "*". Violations may be punished by fines of up to 50 000 EUR.
NW701 Between treated areas which have an incline of more than 2 % and surface waters - including periodically but excluding occasionally water-bearing surface waters - there must be a buffer zone under complete plant cover. The buffer zone's protective function must not be impaired by the use of implements. It must be at least 10 m wide. This buffer zone is not necessary if: -sufficient catching systems are available for the water and soil transported by run-off, which do not flow into surface water or are not connected with the urban drainage system or -the product is used for conservation or no-tillage methods.