Data as of: 2026-08-05 Administration DE EN
Plant Protection Product Search

« Indications · to the product

Spirox

Use number: 008673-00/00-001

Crops
grape vine
Pests
powdery mildew of grape (Uncinula necator)
Area of use
Outdoors
Field of activity
Fungicide
Application technique
spraying or fine spraying (low volume spraying)
Growth stage
13 – 71
Applications per crop
Applications per growing season
2
authorised until
2027-05-31

Application rates

ConditionProduct rateWater rate
BAW 0.2 LH – – 400 LH
ES61 0.4 LH – – 800 LH
ES71 0.6 LH – – 1,200 LH

Pre-harvest intervals

CropPre-harvest intervalRemarksexcluded
grape vine 35 days EWTK

Timing of application

Purpose of use

Restrictions

Code Text Crop Buffer zone
NN234 The product is classified as slightly harmful for populations of the species Typhlodromus pyri (predatory mite).
WW762 Due to resistance management, do not apply the product (including other products with the same active substance, with an active substance from the same active substance group or with a cross-resistant active substance) more often than is stated in the instructions for use. If in doubt, consult extension services.
NW706 Between treated areas which have an incline of more than 2 % and surface waters - including periodically but excluding occasionally water-bearing surface waters- there must be a buffer zone under complete plant cover. The buffer zone's protective function must not be impaired by the use of implements. It must be at least 20 m wide. This buffer zone is not necessary if: -sufficient catching systems are available for the water and soil transported by run-off, which do not flow into surface water or are not connected with the urban drainage system or -the product is used for conservation or no-tillage methods.
NW607-1 When applying the product on areas adjacent to surface waters - except only occasionally but including periodically water bearing surface waters - the product must be applied with equipment which is registered in the index of 'Loss Reducing Equipment' of 14 October 1993 ('Bundesanzeiger' [Federal Gazette] No 205, p. 9780) as amended. Depending on the drift reduction classes for the equipment stated below, the following buffer zones must be kept from surface waters. In addition to the minimum buffer zone from surface waters stipulated by state law, the ban on application in or in the immediate vicinity of waters must be observed at all times for drift reduction classes marked with "*". Violations may be punished by fines of up to 50 000 EUR.