Data as of: 2026-08-05 Administration DE EN
Plant Protection Product Search

« Indications · to the product

ASKON

Use number: 006902-00/14-002

Crops
woody nursery plants
Pests
fungal leaf spot diseases, powdery mildew, rust fungi (Uredinales)
Area of use
Outdoors
Field of activity
Fungicide
Application technique
spraying
Growth stage
19 – 91
Applications per crop
Applications per growing season
1
Type of authorisation
Permit (minor use)
authorised until
2027-03-15

Application rates

ConditionProduct rateWater rate
1 LH 200 – 1,000 LH

Pre-harvest intervals

CropPre-harvest intervalRemarksexcluded
woody nursery plants The setting of a PHI is without any relevance.

Timing of application

Restrictions

Code Text Crop Buffer zone
SF276-ZB After application in ornamentals and nursery, it must be ensured that long-sleeved working clothes, sturdy footwear and protective gloves are worn during successive work/inspections with direct contact with the treated crops/areas.
NW800 Application not allowed on drained areas between 1 November and 15 March.
NW705 Between treated areas which have an incline of more than 2 % and surface waters - including periodically but excluding occasionally water-bearing surface waters - there must be a buffer zone under complete plant cover. The buffer zone's protective function must not be impaired by the use of implements. It must be at least 5 m wide. This buffer zone is not necessary if: -sufficient catching systems are available for the water and soil transported by run-off, which do not flow into surface water or are not connected with the urban drainage system or -the product is used for conservation or no-tillage methods.
NW606 The only case in which the product may be applied without loss reducing equipment is when at least the buffer zone stated below is kept from surface waters - except only occasionally but including periodically water bearing surface waters. Violations may be punished by fines of up to 50 000 Euro. 15 m
NW605-1 When applying the product on areas adjacent to surface waters - except only occasionally but including periodically water bearing surface waters - the product must be applied with equipment which is registered in the index of 'Loss Reducing Equipment' of 14 October 1993 ('Bundesanzeiger' [Federal Gazette] No 205, p. 9780) as amended. Depending on the drift reduction classes for the equipment stated below, the following buffer zones must be kept from surface waters. In addition to the minimum buffer zone from surface waters stipulated by state law, the ban on application in or in the immediate vicinity of waters must be observed at all times for drift reduction classes marked with "*".