| NW607 |
When applying the product on areas adjacent to surface waters - except only occasionally but including periodically water bearing surface waters - the product must be applied with equipment which is registered in the index of 'Loss Reducing Equipment' of 14 October 1993 ('Bundesanzeiger' [Federal Gazette] No 205, p. 9780) as amended. Depending on the drift reduction classes for the equipment stated below, the following buffer zones must be kept from surface waters. In addition to the minimum buffer zone provided for by state law, § 6 (2) 2nd sentence of the 'PflSchG' (German Plant Protection Act) must be observed for the drift reduction classes marked with "*". Violations may be punished by fines of up to 50 000 Euro. |
– |
– |
| NT103 |
In a strip at least 20 m wide which is adjacent to other areas, the product must be applied using loss reducing equipment which is registered in the index of 'Loss Reducing Equipment' of 14 October 1993 (Federal Gazette No 205, p. 9780) as amended, and be registered in at least drift reducing class 90 % (except agriculturally or horticulturally used areas, roads, paths and public places). Loss reducing equipment is not required if the product is applied with portable plant protection equipment or if adjacent areas (field boundaries, hedges, groups of woody plants) are less than 3 m wide or the product is applied in an area which has been declared by the Biologische Bundesanstalt in the "Index of regional proportions of ecotones" of 7 February 2002 (Federal Gazette no. 70 a of 13 April 2002), as amended, as agrarian landscape with a sufficient proportion of natural and semi-natural structures. |
– |
– |
| SB110 |
The directive concerning requirements for personal protective gear in plant protection, "Personal protective gear for handling plant protection products" of the Federal Office of Consumer Protection and Food Safety must be observed. |
– |
– |
| SF1891 |
Re-entering the treated areas/crops is only possible on the day of application wearing personal protective equipment which is specified for applying the particular product. Successive work on/in treated areas/crops may fundamentally not be carried out until 24 hours after applying the product. Within the first 48 hours, protective suits against pesticides and standard protective gloves (plant protection) are to be worn. |
– |
– |
| SS110 |
Wear standard protective gloves (plant protection) when handling the undiluted product. |
– |
– |
| SS2202 |
Wear a protective suit against pesticides and sturdy shoes (e.g. rubber boots) when applying/handling the product ready for application. |
– |
– |
